So before I blow everything up again, how can I have the Ruckus router start handing out DHCP addresses so that I can remove the old AirPort Express and plug the Ruckus directly into the cable modem? I'm again able to access the GUI and everything appears to be normal. One of the two AP starting broadcasting a weird name that it was not connected to something it wanted (the Ruckus router probably?) and no matter what I did, I could not get connected to anything.Īfter reconnecting everything back the way it was and another reboot of the Ruckus router it thankfully starting pulling an IP address from the little AirPort Express again and the two APs seem happy once again as well. I tried manually setting my laptop's IPv4 to match the DHCP network the Ruckus was supposed to be handing out, but I still couldn't ping anything, including the Ruckus router. I connected my laptop to the Ruckus router via ethernet and although the status lights were all on for each ethernet cable plugged in (that had a device), I was not getting an IP address issued to my laptop. I powered down the Ruckus router and the cable modem, turned on the cable modem first since that's been important in the past at times, once it was booted up I fired up the Ruckus router. I hit apply settings and nothing seemed to happen after several minutes. I left the WAN IP address set to DHCP since the cable modem hands out a single real-world IP. I left everything else to the default entries (if my brother uses all 2,000 IPs it makes available to hand out, we're going to have a talk). When I check the box, I set the "WAN PORT" to 1 since that is where the ethernet cable from the cable modem is plugged into. A quick poke around the admin GUI for the Ruckus router and I discovered the "Gateway Mode" checkbox was unchecked in Admin & Services -> System -> IP Settings I'm visiting in person so I thought this would be a great time to remove the AirPort from the network topology since it's quite old and likely reducing his throughput to the internet. There was some other issues with the setup even after it starting working so he eventually reached Ruckus telephone support and for whatever reason the support person either didn't notice the AirPort Express was acting as the DHCP server instead of the Ruckus equipment or didn't care, but this setup has remained for awhile now. So Arris Cable Modem -> AirPort Express -> Ruckus (all via ethernet cables). I discovered nothing was issuing DHCP addresses so we connected an old Apple AirPort Express he had between the Ruckus router and the cable modem and everything came online. To perform a hard reset, hold the reset button for 10 seconds, then set up the base station once again.When my brother moved into a Lennar home his Ruckus system wasn't allowing connected wired or wireless users to the internet. Try this after all other troubleshooting tips have failed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |